31.8s

 

Rob's 22 frame is ready to go. Most of the past few week's work has been outsourcing

 One hard peg chink and the aluminum 20mm axle that I made stripped out. I lathed down a hollow steel one, but I'm not sure a shitty old thru axle hub can take peg abuse like a BMX hub. If this fails I'll just make a thru axle rigid fork.

 Apparently, the unintended micro knurl grips better than expected (after coating) Best of these three actually:

Cody is still rocking his 9" bars. In reference to the rust on the bends: "that's from all the hang five bails"... Inferred subtext: (and I've never regretted a single decision since riding with these bars)

Moto Grom bars

These bars sit between stanchions/fork legs that are 6" apart and within a 4" wide clamp. The vertical sections were ovalized to allow the weld area some room. 29" wide, 3 up, 6.5 back and pretty heavy as they are .083" thick (my BMX bars are .065")